Single-Stage Power Electronic Converters with Combined Voltage Step-Up/Step-Down Capability

Power electronic converters are typically either step-down converters that take an input voltage and produce an output voltage of low amplitude or step-up converters that take an input voltage and produce an output voltage of higher amplitude. There are, however, applications where a converter that can step-up voltage or step-down voltage can be very useful, such as in applications where a converter needs to operate under a wide range of input and output voltage conditions such as a grid-connected solar inverter. Such converters, however, are not as common as converters that can only step down or step up voltage because most applications require converters that need to only step down voltage or only step up voltage and such converters have better performance within a limited voltage range than do converters that are designed for very wide voltage ranges. Nonetheless, there are applications where converters with step-down and step-up capability can be used advantageously. The main objectives of this thesis are to propose new power electronic converters that can step up voltage and step down voltage and to investigate their characteristics. This will be done for two specific converter types: AC/DC single-stage converters and DC-AC inverters. In this thesis, two new AC/DC single-stage converters and a new three-phase converter are proposed and their operation and steady-state characteristics are examined in detail. The feasibility of each new converter is confirmed with results obtained from an experimental prototype and the feasibility of a control method for the inverter is confirmed with simulation work using commercially available software such as MATLAB and PSIM

Analysis and Design of a Higher Current ZVS-PWM Converter for Industrial Applications

A new auxiliary circuit that can be implemented in DC-DC and AC-DC ZVS-PWM converters is proposed in the paper. The circuit is for ZVS-PWM converters used in applications where high-frequency operation is needed and the load current is higher than that of typical ZVS-PWM converters. In the paper, the operation of a new ZVS-PWM converter is described, its steady-state operation is analyzed, and a procedure for its design is derived and then demonstrated. The feasibility of the new converter is confirmed by experimental results obtained from a prototype

Analysis and Design of a Higher Current ZVS-PWM Converter for Industrial Applications

electronic

Lyapunov-based adaptive state of charge and state of health estimation for lithium-ion batteries

This paper presents an adaptive state of charge (SOC) and state of health (SOH) estimation technique for lithium-ion batteries. The adaptive strategy estimates online parameters of the battery model using a Lyapunov-based adaptation law. Therefore, the adaptive observer stability is guaranteed by Lyapunov's direct method. Since no a priori knowledge of battery parameters is required, accurate estimation is still achieved, although parameters change due to aging or other factors. Unlike other estimation strategies, only battery terminal voltage and current measurements are required. Simulation and experimental results highlight the high SOC and SOH accuracy estimation of the proposed technique